*OUT OF STOCK
Every spa and pool owner battles with algae invasion at some point – but you can win the battle with the aid of Pool Poppit’s fast acting pool algicide.
It also acts as a conditioner and clarifier to give you sparkling clear pool water in addition to killing off algal blooms. It will clear algae within 48 hours, without affecting the standard sanitiser level.
You may not see algae but you may have an issue if your sanatiser use goes up dramatically.
Should this occur we would recommend the following:
1. Following the dosing instruction on the back of the package (and below here) and calculate the amount required for your size of spa (dosing instructions are for larger pools). This package is designed for pools and will provide a large number of uses for typical spas. Premix the correct amount of each colour sachet in a bucket of water. When dissolved, pour into the spa. Recommended pH at 6.8 – 7 for Algicide to be more effective.
Pool dosing instructions:
For pool sizes up to:
25,000L use one sachet of each colour (1x Pack 1, 2 & 3. If your spa is 1000L you would use 1/25th of each packet.)
50,000L use two sachets of each colour (2 x Pack 1, 2 & 3)
70,000L (& over) use three sachets of each colour (3 x Pack 1, 2 & 3)
2. Remove filter cartridges and circulate for 4 hours. (Water will initially go cloudy) Turn air jets on and off several times during this time. Put back filter cartridges and filter for an additional 4 hours for a total 8 hours.
3. At the same time, using a damp cloth with Poppits, wipe inside of spa and around jets, under head rests and the underside of the spa cover. Rinse off spa cover and leave exposed to the sun.
4. Burn off dead algae with Poppits Quick Fix Shock at 60grams/1000 liters and filter for 4 hours . Then clean filter cartridges, thoroughly rinse and flush the filter cartridges until water runs clear through the filter cartridges.
(a) If required, balance water with Poppits Water Balance or Spa Fresh Alkalinity increaser (alkalinity 120ppm, pH 7.6).
(b) Finally, dose the spa with Spa Poppits or Spa Fresh bactericide/sanitizer at the rate of 1 litre/1000 litres of water.
FOR SEVERE INFESTATION:
Details:
Manufacturer: Spa Pool Poppits
Model: 125622
Size: 1 Kg
Sold individually
Any advice or suggestions above, including but not limited to instructions and dosing rates are intended to be a guide only.
Spa Store and its staff recommend you read the full instructions on all chemical containers. We will not accept responsibility for the use of these products.
Have a chemical question?
Spa chemicals cannot be shipped to a Post Box. Please provide a physical address during checkout.
Selection Tips
SKU | 125622-OBSOLETE |
Model # | 125622 |
Brand | Poppit® |
Shipping Weight | 1.0000kg |
Shipping Width | 0.190m |
Shipping Height | 0.040m |
Shipping Length | 0.320m |
Shipping Cubic | 0.002400000m3 |
Unit Of Measure | ea |
Every spa and pool owner battles with algae invasion at some point – but you can win the battle with the aid of Pool Poppit’s fast acting pool algicide.
It also acts as a conditioner and clarifier to give you sparkling clear pool water in addition to killing off algal blooms. It will clear algae within 48 hours, without affecting the standard sanitiser level.
You may not see algae but you may have an issue if your sanatiser use goes up dramatically.
Should this occur we would recommend the following:
1. Following the dosing instruction on the back of the package (and below here) and calculate the amount required for your size of spa (dosing instructions are for larger pools). This package is designed for pools and will provide a large number of uses for typical spas. Premix the correct amount of each colour sachet in a bucket of water. When dissolved, pour into the spa. Recommended pH at 6.8 – 7 for Algicide to be more effective.
Pool dosing instructions:
For pool sizes up to:
25,000L use one sachet of each colour (1x Pack 1, 2 & 3. If your spa is 1000L you would use 1/25th of each packet.)
50,000L use two sachets of each colour (2 x Pack 1, 2 & 3)
70,000L (& over) use three sachets of each colour (3 x Pack 1, 2 & 3)
2. Remove filter cartridges and circulate for 4 hours. (Water will initially go cloudy) Turn air jets on and off several times during this time. Put back filter cartridges and filter for an additional 4 hours for a total 8 hours.
3. At the same time, using a damp cloth with Poppits, wipe inside of spa and around jets, under head rests and the underside of the spa cover. Rinse off spa cover and leave exposed to the sun.
4. Burn off dead algae with Poppits Quick Fix Shock at 60grams/1000 liters and filter for 4 hours . Then clean filter cartridges, thoroughly rinse and flush the filter cartridges until water runs clear through the filter cartridges.
(a) If required, balance water with Poppits Water Balance or Spa Fresh Alkalinity increaser (alkalinity 120ppm, pH 7.6).
(b) Finally, dose the spa with Spa Poppits or Spa Fresh bactericide/sanitizer at the rate of 1 litre/1000 litres of water.
FOR SEVERE INFESTATION:
Details:
Manufacturer: Spa Pool Poppits
Model: 125622
Size: 1 Kg
Sold individually
Any advice or suggestions above, including but not limited to instructions and dosing rates are intended to be a guide only.
Spa Store and its staff recommend you read the full instructions on all chemical containers. We will not accept responsibility for the use of these products.
Have a chemical question?
Spa chemicals cannot be shipped to a Post Box. Please provide a physical address during checkout.
Selection Tips
SKU | 125622-OBSOLETE |
Model # | 125622 |
Brand | Poppit® |
Shipping Weight | 1.0000kg |
Shipping Width | 0.190m |
Shipping Height | 0.040m |
Shipping Length | 0.320m |
Shipping Cubic | 0.002400000m3 |
Unit Of Measure | ea |
Every spa and pool owner battles with algae invasion at some point – but you can win the battle with the aid of Pool Poppit’s fast acting pool algicide.
It also acts as a conditioner and clarifier to give you sparkling clear pool water in addition to killing off algal blooms. It will clear algae within 48 hours, without affecting the standard sanitiser level.
You may not see algae but you may have an issue if your sanatiser use goes up dramatically.
Should this occur we would recommend the following:
1. Following the dosing instruction on the back of the package (and below here) and calculate the amount required for your size of spa (dosing instructions are for larger pools). This package is designed for pools and will provide a large number of uses for typical spas. Premix the correct amount of each colour sachet in a bucket of water. When dissolved, pour into the spa. Recommended pH at 6.8 – 7 for Algicide to be more effective.
Pool dosing instructions:
For pool sizes up to:
25,000L use one sachet of each colour (1x Pack 1, 2 & 3. If your spa is 1000L you would use 1/25th of each packet.)
50,000L use two sachets of each colour (2 x Pack 1, 2 & 3)
70,000L (& over) use three sachets of each colour (3 x Pack 1, 2 & 3)
2. Remove filter cartridges and circulate for 4 hours. (Water will initially go cloudy) Turn air jets on and off several times during this time. Put back filter cartridges and filter for an additional 4 hours for a total 8 hours.
3. At the same time, using a damp cloth with Poppits, wipe inside of spa and around jets, under head rests and the underside of the spa cover. Rinse off spa cover and leave exposed to the sun.
4. Burn off dead algae with Poppits Quick Fix Shock at 60grams/1000 liters and filter for 4 hours . Then clean filter cartridges, thoroughly rinse and flush the filter cartridges until water runs clear through the filter cartridges.
(a) If required, balance water with Poppits Water Balance or Spa Fresh Alkalinity increaser (alkalinity 120ppm, pH 7.6).
(b) Finally, dose the spa with Spa Poppits or Spa Fresh bactericide/sanitizer at the rate of 1 litre/1000 litres of water.
FOR SEVERE INFESTATION:
Details:
Manufacturer: Spa Pool Poppits
Model: 125622
Size: 1 Kg
Sold individually
Any advice or suggestions above, including but not limited to instructions and dosing rates are intended to be a guide only.
Spa Store and its staff recommend you read the full instructions on all chemical containers. We will not accept responsibility for the use of these products.
Have a chemical question?
Spa chemicals cannot be shipped to a Post Box. Please provide a physical address during checkout.
Selection Tips
SKU | 125622-OBSOLETE |
Model # | 125622 |
Brand | Poppit® |
Shipping Weight | 1.0000kg |
Shipping Width | 0.190m |
Shipping Height | 0.040m |
Shipping Length | 0.320m |
Shipping Cubic | 0.002400000m3 |
Unit Of Measure | ea |
We are proud that Spa World customers have given us a Five Star Trustpilot rating.
For peace of mind
With a Spa Store Account
on AU orders over $199*
With 7-day online chat support