SpaCare™ PH UP 500ml

• pH Up is used to raise the pH value of a spa or hot tub to the required level of 7.2 to 7.6 without affecting Alkalinity Levels.
• These levels between 7.2 to 7.6, are the ideal ones to promote bather comfort, optimum chemical efficiency and protection of spa or hot tub equipment.

Directions: 

Test the pH of your spa or hot tub water
If the reading is below 7.2, use pH Up to raise it according to the dosage chart below:

• Below 6.8  10g for every 1000L
• 6.8 – 7.0  8g for every 1000L
• 7.0 – 7.2  6g for every 1000L

Applications Instructions:

• Pre-dissolve the product in a clean plastic container of clean warm water.
• Stir well to ensure product is fully dissolved.
• Carefully add the solution to the spa or hot tub whilst the pump is turned on, preferably near the water inlets to aid distribution.
• After a minimum of 6 hours, recheck the pH level and, if necessary, repeat the treatment until the ideal pH is obtained.
• Please note a number of treatments may be required.

Size: 500ml

Model: LC-PHUP

Manufacturer: SpaCare

Sold individually

Any advice or suggestions above, including but not limited to instructions and dosing rates are intended to be a guide only. Spa World and its staff recommend you read the full instructions on all chemical containers.
We will not accept responsibility for the use of these products.

Have a chemical question?

Download Product MSDS

Chemical FAQs

Spa chemicals cannot be shipped to a Post Box. Please provide a physical address during checkout.

Selection Tips

• Check your current water treatment type.
• Is your system chlorine-based, non-chlorine?
• Check your pool volume.

Still not sure this is the correct chemical? Contact us.

DOWNLOAD INFORMATION