OBSOLETE - This product is no longer available.

There is currently no direct replacement.

Poppits Pool Algicide Conditioner Clarifier

Product Features

• Long lasting - up to 3-4 months 
• Works in synergy with the sanitiser
• Helps to protect against UV damage
• Is suitable for most types of pools
• Acts as a conditioner and clarifier to provide clear in addition to killing off algal blooms
• Clears algae within 48 hours, without affecting the standard sanitiser level

Take note of these early warning signs of algae growth:

• Water not crystal clear
• Uses excessive amounts of Spa Poppit bactericide/sanitiser
• Incidence of cough when close to the spa due to airborne algae & carried in with the spa users
• You may not see algae but you may have an issue if your sanatiser use goes up dramatically.

Pool dosing instructions for pool sizes:

• 25,000L use one sachet of each colour (1x Pack 1, 2 & 3. If your spa is 1000L. use 1/25th of each packet
• 50,000L use two sachets of each colour (2 x Pack 1, 2 & 3)
• 70,000L (& over) use three sachets of each colour (3 x Pack 1, 2 & 3)

1.  Remove filter cartridges and circulate for 4 hours. (Water will initially go cloudy) Turn air jets on and off several times during this time. Put back filter cartridges and filter for an additional 4 hours for a total 8 hours.
2. 3. At the same time, using a damp cloth with Poppits, wipe inside of spa and around jets, under head rests and the underside of the spa cover. Rinse off spa cover and leave exposed to the sun.
3. 4. Burn off dead algae with Poppits Quick Fix Shock at 60grams/1000 liters and filter for 4 hours . Then clean filter cartridges, thoroughly rinse and flush the filter cartridges until water runs clear through the filter cartridges.
4. (a) If required, balance water with Poppits Water Balance or Spa Fresh Alkalinity increaser (alkalinity 120ppm, pH 7.6).
5. (b) Finally, dose the spa with Spa Poppits or Spa Fresh bactericide/sanitizer at the rate of 1 litre/1000 litres of water.

FOR SEVERE INFESTATION:

1.  Remove the filter cartridges, add Poppit or Pipe Degreaser;
2.  Circulate for 30 minutes & dump water out
3.  Refill, going through the normal start up procedures;
4.  Add the other half of each sachet of Pool Poppits algicide as above.

Specifications

• Size: 1 Kg
• Model: 125622
• Manufacturer: Spa Pool Poppits

Any advice or suggestions above, including but not limited to instructions and dosing rates are intended to be a guide only. Spa World and its staff recommend you read the full instructions on all chemical containers. We will not accept responsibility for the use of these products.

Spa Poppits Instructions

Click to view SDS

Spa chemicals cannot be shipped to a Post Box. Please provide a physical address during checkout.

Got more questions?

Talk to us on live chat, or email us your spa questions and we'll be happy to help!